GENERAL MERCHANDISE SECTION RED PART NUMBERS INDICATE NEW PARTS 10-56 1 2 3 4 5 6 7 8 9 10 11 CONTENTS REFERENCE GENERAL EXHAUST FUEL DRIVE TRAIN ENGINE WHEEL CONTROL FRONT END FRAME ELECTRICAL Fits Milwaukee-Eight® & Twin Cam Models. Cylinder hold down nuts are an effective way to keep the cylinders in place, when the heads are removed from the engine. This is particularly useful when installing the second cylinder over the piston and rings, after the first cylinder has been installed. In any case, even a slight rocking of the cylinder can damage the base gasket or cause a cylinder to lift entirely off the cases. These new JIMS® Hold Down Nuts have different threads at each end. One end fits Twin Cam® models, while the other end works with Milwaukee-Eight® engines. Sold as a set of 2. Part 60857 EXHAUST STUD DRILL PLATE FOR ALL EVOLUTION AND TWIN CAM Part 60835 • For all Evolution models & Twin Cam. • Designed to guide and keep alignment of the included 1/4” drill bit in order to drill out a broken exhaust stud. • Follow up the drilling process with a tap, and you are ready to install a new exhaust stud. • CNC machined from billet aluminum and anodized to protect the finish. • Hardened drill bushing to prevent the drill bit from damaging the main body. • Can be used without removing the head on any stud with the proper frame clearance. • Instructions are included. Wheel, Brake, & Miscellaneous Tools 25MM WHEEL BEARING REMOVER & INSTALLER TOOL • Used to remove and install 25mm I.D. wheel bearings. • Note: Must be used with our 57914 wheel bearing installer/remover tool on Page 10-53 . Fits all models with 25mm bearings 2007/Later Fits Big Twin Late 1985/Later & Sportster 1986/Later Fits Big Twin Late 1985/Later & Sportster 1986/Later Part 57920 Part 60797 Part 60796 FERRULE INSTALLATION TOOLS FOR “CUT TO FIT” BRAIDED BRAKE HOSE CYLINDER STUD REMOVAL TOOL FOR EVOLUTION AND TWIN CAM • Used to separate the braided stainless steel jacket away from the inner lining & open the bore for easy installation of the ferrule. • For easy removal of cylinder studs. • Made of 3/4” hex high tensile steel with 3/8-16 internal thread with left hand locking jam bolt for easy removal of stud. • For easy installation of cylinder studs. • Made of 5/8” hex high tensile steel with 3/8-16 internal thread with captivated hardened ball bearing. • Dimensionally set 1” from top of tool. • Add 1” when measuring from top of tool to engine case to achieve installed height. Fitment Part # -3 (dash three) hose 40200 -2 (dash two) hose 40202 CYLINDER STUD INSTALLATION TOOL FOR EVOLUTION AND TWIN CAM EASY BRAKE BLEEDER FOR ALL MODELS Motion Pro has developed a unique brass bodied tool that makes bleeding your brakes a one-person job. The unique check valve allows fluid and air to escape while preventing air to re-enter the system. Once this unit is primed with brake fluid, simply attach the hose to the caliper bleeder screw and place the other end into a bottle. Follow the included directions. Once all the air is bled from the brake line, close the bleeder screw on the caliper and remove hose. Fits all models with hydraulic brakes. Part 57910 VALVE STEM CORE TOOL FOR ALL TIRES • All steel tool used to remove & replace the valve stem core on all tube or tubeless type tires. • Hex shape for a good grip. • Total length 2 3/4”. Part 57912 CYLINDER HOLD DOWN NUTS
RkJQdWJsaXNoZXIy MzYzNTI=