GENERAL MERCHANDISE SECTION RED PART NUMBERS INDICATE NEW PARTS 10-70 1 2 3 4 5 6 7 8 9 10 11 CONTENTS REFERENCE GENERAL EXHAUST FUEL DRIVE TRAIN ENGINE WHEEL CONTROL FRONT END FRAME ELECTRICAL Twin Cam Tools TWIN CAM TOOLS Due to the radical new design of the Twin Cam, specialized tools are required to properly perform engine repair without damage. All JIMS® tools are manufactured from top quality material, and designed for years of trouble free service. All tools include instructions. Part 60827 CAM CHAIN TENSIONER TOOL This tool will unload the pressure on the primary and secondary chain tensioners to assemble and disassemble cams. It also checks spring loads on chain tensioners. (Rpls. HD 42313) Part 60809 CAM ASSEMBLY TOOL Use this tool to hold both cams in an upright position while lowering the cam support plate over both guides and cam journal guides. This tool has been manufactured from a non-marring material, that will not damage any of the cam’s surfaces. Use on all Twin Cam 2007/Later, and 2006/Later Dyna. CAMSHAFT REMOVER AND INSTALLATION TOOL This multifunction tool will remove and replace front and rear camshafts and the ball bearings. Use on all Twin Cam 1999/Early 2000 to remove and install cams and bearings. Use on all Late 2000/2006 and FXD 2000/2005 to remove and install cams only. It provides the precision alignment of the camshaft to insure a smooth press in and out of the support plate. (Rpls HD 43644) Part 60829 INNER CAM BEARING REMOVERS This blind hole puller will easily remove the crankcase needle bearing that supports the camshafts. The unique design prevents the pin rollers from accidentally falling into the crankcase, that is known to happen when using inferior pullers. CAM BEARING INSTALLATION TOOLS This tool will install the two inner cam needle bearings into the crankcase. It perfectly aligns to the shaft bores for a precision press fit. CAMSHAFT/CRANKSHAFT LOCKING TOOLS These precision tools allow the technician to lock the camshaft and crankshaft sprockets to properly remove, replace, and torque the sprocket bolts. These tools are made from non-marring delrin. (Rpls. HD 42314) Model & Year Part # Twin Cam 1999/2006 (except 2006 Dyna) 60831 Twin Cam 2007/Later & Dyna 2006/Later 60810 Model & Year Part # All Twin Cams 60830 Collar Only Fits All Twin Cams 60807 Model & Year Part # Twin Cam 2000/2006 60828 (except 2006 Dyna) Twin Cam 2007/Later 60808 & Dyna 2006/Later
RkJQdWJsaXNoZXIy MzYzNTI=