GENERAL MERCHANDISE SECTION RED PART NUMBERS INDICATE NEW PARTS 10-73 1 2 3 4 5 6 7 8 9 10 11 CONTENTS ELECTRICAL FRAME FRONT END CONTROL WHEEL ENGINE DRIVE TRAIN FUEL EXHAUST GENERAL REFERENCE Clutch Tools Belt Tension Gauge & Chain Tools CHAIN BREAKING & RIVETING TOOL KIT FOR ALL MODELS This tool is designed to rivet chain links to form an endless chain. May be used on cam chains or drive chain. Tool may also be used to break chain by pushing pin out. Tool includes 3 sizes of hardened steel breaking tips, 1 riveting tip, upper and lower tip guides, large and small anvils, heavy duty cast steel body, hardened alignment bolt and pusher bolt. All in a heavy duty plastic storage case. Most rear drive chains now are using press on side plates with clip type connection links which cannot be installed without the aid of a special tool. The included press pad set will allow you to easily install side plates on all 520 and 530 size chain including O ring types. Part 70407 • For use on all 1998/Later models except applications with hydraulic clutches. • Deep socket allows tool to recess into clutch basket and can be driven with 11/16” combination or adjustable wrench. • Through hole allows access with hex wrench to hold clutch adjuster screw while simultaneously tightening the adjuster lock-nut. • Heavy duty tool for shop or home use. • Compact design fits easily in the saddle or tool bag. CLUTCH SPRING COMPRESSOR FOR SPORTSTER 1971/EARLY 1984 This steel Clutch Spring Compressor is a necessity any time the clutch is removed or replaced. Clutch springs are under extreme pressure and very dangerous if not used with the proper tool. Fits Sportster models with generator charging system 1971/Early 1984. (Rpls. HD 97178-71) Part 70416 CLUTCH HUB PULLER TOOL FOR BIG TWIN 1941/1989 Part 70418 CLUTCH ADJUSTER NUT TOOL REAR BELT TENSION GAUGE Part 70442 Part 70425 Fits all Rear Belt Drive Models 1980/Later (Rpls. HD 40006-85 or Kent-Moore #35381) • Designed to gauge the correct tension on the belt when checking for the specified deflection. • The body of the tool is graduated in 1/8” increments with a slidable O-ring to use as a reference point when checking deflection. • The plunger includes a slidable O-ring that can be preset at the desired pressure (in pounds) to simplify the job. Clutch Hub Puller Tool for use on Big Twin 10 spring clutch with 3 studs only and Big Twin diaphragm clutch 1984/1989. All stud holes are conveniently marked to identify which holes to use. This heavy duty steel tool does not require the removal of the clutch release pushrod. Complete with 4 long bolts for diaphragm hub. (Rpls. HD 95960-41A & 95960-52C).
RkJQdWJsaXNoZXIy MzYzNTI=