GENERAL MERCHANDISE SECTION RED PART NUMBERS INDICATE NEW PARTS 10-75 1 2 3 4 5 6 7 8 9 10 11 CONTENTS ELECTRICAL FRAME FRONT END CONTROL WHEEL ENGINE DRIVE TRAIN FUEL EXHAUST GENERAL REFERENCE Transmission Shift Fork & Alignment Tools • Safely install a new bearing using hand tools. • Job can be performed with the transmission still in the frame. • Holds bearing square to it’s bore, eliminating any marring of the bearing bore. The gear shift foot lever/pedal bushings on 5 & 6 speed HarleyDavidson Touring Models often have a typical service life of 20,000 miles or less. Bushing wear results in an annoying rattle from the loose shifter, the linkage parts and accelerated wear of all related parts. Easily removes both worn bushings at the same time and quickly installs the new bushings to the proper location without removing the inner primary. Using this tool can remove and install the bushings in approximately 20 minutes. MAIN DRIVE GEAR AND BEARING TOOL FOR 5 SPEED TRANSMISSION • Removes and installs the main drive gear and bearing without removing the transmission case from the bike. • Will not damage the bearing or main drive gear during installation. Use on Big Twin 1980/Later, Sportster & Buell® 1991/Later Use on Dyna 2006/Later, FL & FXST 2007/Later Part 70438 NEEDLE BEARING PULLER FOR BIG TWIN & SPORTSTER SHIFT PEDAL SHAFT BUSHING TOOL What was once a difficult bearing to remove, can now be done with the greatest of ease. Includes instructions. Removes the following bearings: • HD bearing 9063 (our 67504) found in the outer primary cover to support the starter shaft on Big Twin 1965/1988 and Sportster 1967/1980. • HD bearing 35961-52 (our 72930) found in the 4 speed transmission countershaft gear on Big Twin Late 1967/Later, the clutch gear on Sportster 4 speed, all years, and the access door on Sportster 4 speed, all years. PRIMARY CAP INSTALLATION TOOL FOR SPORTSTER EVOLUTION MODELS Use of this zinc plated steel tool will prevent damage to primary caps on all Sportster Evolutions 1986/1990. Part 78584 6 SPEED TRANSMISSION MAIN BEARING INSTALLER TOOL AEROSPACE STEEL Part 70440 Part 70408 Part 70462
RkJQdWJsaXNoZXIy MzYzNTI=