GENERAL MERCHANDISE SECTION RED PART NUMBERS INDICATE NEW PARTS 10-78 1 2 3 4 5 6 7 8 9 10 11 CONTENTS REFERENCE GENERAL EXHAUST FUEL DRIVE TRAIN ENGINE WHEEL CONTROL FRONT END FRAME ELECTRICAL Transmission Tools Use to remove the larger 2 1/4” hex nut from the end of main drive gear, which secures the rear drive trans pulley. Very safe and easy to use. Just thread on the inner support collar to end of mainshaft, place the socket over the collar with your favorite 1/2” drive tool, and unthread (right hand thread) locknut. TRANSMISSION MAINSHAFT PULLEY LOCKNUT SOCKET TOOL Fits Big Twin 1936/2006 (except Dyna 2006) & Sportster 1991/Later Fit Touring Models, FXST 2007/ Later & Dyna 2006/Later Part 70409 (Rpls. HD 94660-37B) TRANSMISSION SPROCKET/PULLEY NUT WRENCH FOR BIG TWIN • For all length Big Twin transmission mainshafts, so that you can properly torque the sprocket/pulley nut to 100/120 ft. lbs. • For use with 1/2” drive ratchet, impact or torque wrench. • Left hand threaded collar screws on end of mainshaft, and pilots the tool to prevent damaging the sprocket/pulley nut. • Will fit all OEM style sprocket/pulley nuts and the Super Nut. Part 70423 XL SPROCKET NUT SOCKET 5 & 6-SPEED COUNTERSHAFT BEARING REMOVER & INSTALLER TOOL Fits All Sportster & Buell models 1991/Later (except 1125R) Use On All HD Cruise Drive 6-Speed & 1980/2006 5-Speeds, Including Aftermarket 6-Speeds Part 70464 Part 70460 This short socket is designed specifically for XL models to remove, install, and properly tighten the front final drive sprocket/pulley. Although the much longer Big Twin socket will fit the nut, the mainshaft on XL models does not extend through for the guidance collar to ensure correct alignment. This shorter socket is easier and safer to handle, providing full contact to the nut. This new JIMS exclusive tool will install or remove the closed end countershaft bearing on all 5-Speed or 6-Speed Cruise Drive transmissions without using a press, or tapping it in with a transmission shaft. This is a precision hand tool designed to install the bearing square and to the proper depth.
RkJQdWJsaXNoZXIy MzYzNTI=