GENERAL MERCHANDISE SECTION RED PART NUMBERS INDICATE NEW PARTS 10-79 1 2 3 4 5 6 7 8 9 10 11 CONTENTS ELECTRICAL FRAME FRONT END CONTROL WHEEL ENGINE DRIVE TRAIN FUEL EXHAUST GENERAL REFERENCE MAIN DRIVE GEAR BUSHING TOOL FOR BIG TWIN Used to remove and install main drive gear bushings on Big Twin 1936/Later with 4 speed transmissions. Part 70419 This is a real time saver for removing and installing the shifter mechanism sleeve in Cruise Drive Big Twin transmissions. With this new tool, the sleeve (bushing) can be removed and installed correctly without disassembling the transmission, saving hours of labor. This tool will pay for itself with one use. To assist in the assembly of the transmission gears and shafts, JIMS® has developed the Cruise Drive vise stand. No more fumbling with parts on the bench or clamping in a vise with soft jaws.This new tool holds the shafts in perfect alignment, while protecting them from damage. Faster, easier, and safer assembly is now possible. Transmission & Shop Tools Fits All Big Twin 2007/Later & Dyna 2006 with 6-Speed Cruise Drive Transmission Fits Big Twin 2007/Later & Dyna 2006/Later Part 70457 Part 70465 It is now possible to remove the transmission door and assembly without any fuss, with this Transmission Access Door Puller Tool from JIMS®. This tool removes the entire assembly, gears and shafts, without damaging the transmission door bearings. TRANSMISSION ACCESS DOOR PULLER TOOL FOR BIG TWIN 5 SPEED SHIFTER MECHANISM SLEEVE REMOVER & INSTALLER CRUISE DRIVE VISE STAND Part 70431 TRANSMISSION SHAFT INSTALLER FOR BIG TWIN 5 SPEED • This tool pulls the transmission shafts into the access door without the use of a hydraulic or arbor press. Part 70404 For use on Big Twin 5 speed 1980/Later For use on Big Twin 5 speed 1980/Later
RkJQdWJsaXNoZXIy MzYzNTI=