INDEX 1 2 3 4 5 6 7 8 9 10 11 ELECTRICAL SECTION RED PART NUMBERS INDICATE NEW PARTS 1-48 CONTENTS REFERENCE GENERAL EXHAUST FUEL DRIVE TRAIN ENGINE WHEEL CONTROL FRONT END FRAME ELECTRICAL Taillight/License Mounts AXLE MOUNT TAILLIGHT/LICENSE ASSEMBLY FOR SOFTAIL Part 11229 • The axle spacer/adjuster stop is incorporated into the license plate backing plate for a clean look. • Includes a special adapter that will allow for a 3/4” O.D. axle or a 1” O.D. axle. • Hidden allen head lock screws secure the vertically mounted license plate from the backside furnishing you with a smooth, boltless look. • Mounts on left side (replaces axle spacer adjuster stop) • 20 red LED lights for high output and low draw • CNC machined from billet aluminum • Accepts 7” x 4” license plate • Hidden wiring • 12 volt Features REPLACEMENT PARTS Description Part # Taillight housing with lens, LED light board, 11242 wires and mounting hardware Taillight lens only 11708 Fits Softail 1986/1999 REPLACEMENT PARTS Description Part # Taillight housing with lens, LED light board, 11242 wires and mounting hardware Taillight lens only 11708 Note: These taillight assemblies are not DOT approved and should be used accordingly. FENDER MOUNT TAILLIGHT/LICENSE ASSEMBLY FOR CUSTOM USE CURVED STYLE LICENSE MOUNT WITH BACKING PLATE Fits flat or curved rear fender Fits any fender Features Part 11230 Part 13118 • Hidden allen head lock screws secure the license plate from the back furnishing you with a smooth, boltless look. • Included is a rubber mounting block and hardware for a no hassle installation. • 20 red LED lights for high output and low draw • CNC machined from billet aluminum • Accepts 7” x 4” license plate • Hidden wiring • 12 volt Note: These taillight assemblies are not DOT approved and should be used accordingly. Shown Installed Shown Installed License plate slides in from the bottom and secures with hidden hardware • Chrome plated CNC billet aluminum. • License plate slides in from the bottom and is held into place by two set screws that are in the back for a totally smooth look. • Includes rubber spacer to control vibration. • OE type 3 hole mounting with hardware. • 7” x 4” license plate frame. Shown Installed Included Parts LED Style LED Style
RkJQdWJsaXNoZXIy MzYzNTI=