GENERAL MERCHANDISE SECTION RED PART NUMBERS INDICATE NEW PARTS 10-77 1 2 3 4 5 6 7 8 9 10 11 CONTENTS ELECTRICAL FRAME FRONT END CONTROL WHEEL ENGINE DRIVE TRAIN FUEL EXHAUST GENERAL REFERENCE Transmission & Primary Tools • Hold the transmission pulley in place, while loosening or tightening the pulley nut. • Use with transmission sprocket/pulley nut wrench . TRANSMISSION PULLEY LOCKING TOOL Fits Big Twin 1980/Later with rear belt drive Part 70432 Model Part # All Big Twin 4 speed, Softail & Dyna models, all years 70417 FXR & FLT 5 speed, all years 70436 Dyna 2006/Later & FXST 2007/Later 6 speeds 70410 Touring 2007/Later 6 speeds 70411 Milwaukee-Eight® Softail models 2018/Later 70424 PRIMARY DRIVE LOCKING BARS FOR BIG TWIN Avoid damage to the primary driveline with one of these steel Primary Drive Locking Bars from JIMSTM. Depending on application, use these tools to lock the clutch sprocket to the engine sprocket, when the clutch or engine nuts are loosened or tightened. This will allow the proper use of a torque wrench. Saves time and money. Note: Never use an impact wrench, or loosening of the alternator magnets might occur. • Safely install a new or newly repaired main drive gear. • Job can be performed with the transmission still in the frame. • Holds the main drive gear square to it’s bearing bore, eliminating any marring of gear or bearings. Use on Dyna 2006/Later, FL & FXST 2007/Later Part 70406 6 SPEED MAIN DRIVE GEAR INSTALLER TOOL TRANSMISSION STUD INSTALLATION TOOL FOR BIG TWIN Use to easily install transmission mounting studs on Big Twins with solid mount transmissions. Features a ball bearing end on the jam stud that eliminates any possibility of stud damage. Can be used to install any 3/8”-24 stud. Includes instructions. Description Part # Installation tool (as shown) 70439 Jam stud with ball 73234 bearing end only Fits Big Twin 4 speed 1936/Later and Softail 5 speed 1986/1999
RkJQdWJsaXNoZXIy MzYzNTI=